Siemens SINUMERIK - Page 208

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
202 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; "[GeneralSettingsForMagAndToolList]", entry
; "MagPlaceState_Lang_12345678" or "second "TC_TP2""
1_MagList=M1
2_MagList=M2
3_MagList=M3
1_ToolList=T1
2_ToolList=T2
3_ToolList=T3
1_ActList=A1
2_ActList=A2
3_ActList=A3
[FormTitles]
; List display titles for the untransformed display of
; data with locale-dependent and transformation-dependent
; mechanisms. For a transformed display the substitute for the
; text codes is taken from the "[TrafoFormTitles]" section.
; If "ReadLanguageIni=1" in "[General]", then the text is
; read from the locale-dependent file
; (e.g. language\patm_gr.ini), see "[FormTitles]" section.
; In each case the text parameters should be set for all
; list displays, for both transformed and
; untransformed display.
; Pay particular attention to the working offset lists: currently
; these lists are only output with transformed data.
; In this case the list display titles from
; "[TrafoFormTitles]" is used.
1_MagList=M1
2_MagList=M2
3_MagList=M3
1_ToolList=T1
2_ToolList=T2
3_ToolList=T3
1_ActList=A1
2_ActList=A2
3_ActList=A3
[TrafoFormTitles]
; List display titles for untransformed data display
; with locale-dependent and transformation-dependent mechanisms.
; If "ReadLanguageIni=1" in "[General]", then the text is
; read from the locale-dependent file
; see the "[FormTitles]" section.
M1=TM1
M2=TM2
M3=TM3