Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
204 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; Min:=-9999, Max:=9999 ;Comment"
; "UserDataParamIO6=
; Type:=Int, Min:=-99, Max:=99"
; "UserDataParamIO7=
; Type:=Int, Min:=0, Max:=1"
; "5": Number of the OEM data
; "Type:=...": Defines the type of OEM data;
; Default: "Float"
; "Float": Floating point as used in the NC.
; The number of decimal places depends on the MD
; $MM_DISPLAY_RESOLUTION in mmc.ini and on the "res:=..."
; in this parameter line.
; "Int": Integer (range: -999999999 to 999999999)
; "Res:=2": decimal places,
; if "Type:=Float" (floating-point number).
; Range from 0 to 6, default is $MM_DISPLAY_RESOLUTION.
; If "Res:=..." is greater than $MM_DISPLAY_RESOLUTION,
; only the places $MM_DISPLAY_RESOLUTION are displayed.
; Resolution, accuracy: Number of
; "Min:=-9999": For the input: Minimum value
; "Max:=-9999": For the input: Maximum value:
; ";comment": Comment
; Lines UserDataParamName: Locale-specific mechanism
; Lines UserDataParamSize: Locale-specific mechanism
; Lines UserDataParamSizex: Locale-specific mechanism
[ToolParams]
UserDataParamName1 = TC_TPC1
UserDataParamName2 = TC_TPC2
UserDataParamName3 = TC_TPC3
UserDataParamName4 = TC_TPC4
UserDataParamName5 = TC_TPC5
UserDataParamName6 = TC_TPC6
UserDataParamName7 = TC_TPC7
UserDataParamName8 = TC_TPC8
UserDataParamName9 = TC_TPC9
UserDataParamName10 = TC_TPC10
UserDataParamIO1 = <EndOfList>
; UserDataParamIO1 = Type:=Float, Res:=2
; UserDataParamIO2 = Type:=Int
UserDataParamSize = TC_TPC_UNIT
UserDataParamSize1 = <EndOfList>
; UserDataParamSize1=TC_TPC1_UNIT
; ...
; UserDataParamSize10=TC_TPC10_UNIT
ApplDataParamName1 = TC_TPCS1
ApplDataParamName2 = TC_TPCS2
To Next Page
Loading...
Need help?
General
