Tool management
6.4 Job processing of tools
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
249
If this condition is applied to the tool status, you can locate tools with specific set (AND) tool
status bits. If several set bits are queried at the same time, just one set bit is sufficient for the
tool to appear in the hit list.
Comparison Value
For string operands (e.g. tool identifier) "==" is the only permissible comparison operator.
The following value ranges apply:
String: with TC_TP2, maximum of 32 characters, no blanks before or after
0 ... 65535: for the other TC_TP data
Double: for all other data
Additional data
Max. one column with additional data can appear for each filter in the results list.
There are three settings for each filter:
● n_FindResultAddColumnText
Header text for column or reference to the header text with language-specific
settings/locales.
● n_FindResultAddColumnDisplayedNumberOfCharacters
Column width in characters
● n_FindResultAddColumnBtss
OPI item acc. to OPI documentation (mmc2\btss_gr.hlp).
Example 1:
Paramtm.ini, [BatchTools]:
1_FindResultAddColumnText=<empty>
; No additional column
1_FindResultAddColumnText=R1AddCol
; Language-specific
1_FindResultAddColumnDisplayedNumberOfCharacters=8
1_FindResultAddColumnBtss="/Tool/User/data[u#TOA#,c3,#TNO#] (l"!l%ld")"
language\patm_gr.ini, [BatchTools]:
R1AddCol="Additional data search 1"
Example 2:
"/Tool/User/data[u#TOA#,c2,#TNO#](l"!d%.#RES#lf")"
Tool OEM parameter2, floating point representation, standard number of decimal places
Example 3:
"/Tool/User/data[u#TOA#,c3,#TNO#](l"!l%ld")"
Tool OEM parameter3, integer representation
To Next Page
Loading...
Need help?
General
