Tool management
6.7 Start-up of code carrier
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
259
; code-carrier format.
; The file resides in directory ...\add_on or ...\user.
[TIS]
; Tool Identification System
; EOT for code-carrier data
TIS_EOT=0x2F2F
; The end identifier for data on the code carrier has to be
; entered here.
;
Setting for inch/metric in the paramtm.ini file
The excerpts printed below are found in the paramtm.ini. In newer software versions, the
paramtm.ini comments have been summarized in paramtm.txt.
As a general rule, the desired entries are made in ...\user\paramtm.ini so that they are
retained during the next HMI software update.
If the paramtm.ini or paramtm.txt of the software version that has been installed contains one
of the following (variant 1 or variant 2), then the function can be used by making an entry in
...\user\paramtm.ini as described below. Otherwise the default setting applies.
Version 1:
[TMMODES]
...
; The inch/metric setting is considered for the code carrier
; -1 = inch/metric is ignored (default).
; Data transfer between the code carrier and the NCK/MMC takes place
; without consideration of the inch/metric setting. Behavior as up
to now.
; 0=mm
; It is assumed that storage of the data on the code carrier
; is to be executed in the unit mm
. If "inch" is set in the NCK
; all softkeys are disabled and code carrier
; functions start.
;1=inch
; It is assumed that the relevant data has been or is to be
; stored on the code carrier in inches.
. If "mm" is set in the NCK
; all softkeys are disabled and code carrier
; functions start.
DATABASE_LENGTH_UNIT=-1
Version 2:
[TMMODES]
...
; The inch/metric setting is considered for the code carrier
; !! NOTICE: The settings described here are only
; relevant if the machine data
To Next Page
Loading...
Need help?
General
