List of the INI Files
A.23 SEDITOR.INI
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
321
Example:
M4711 is a synchronization that only acts on Channels 1, 2, and 6. The entry must look like
this:
sync2 = M4711
sync2_Ico = clock.bmp
sync2_Chans = 1,2,6
[Old_or_User_Cycles_User]
Machine manufacturers can enter their expansions for their own cycles here.
Examples:
Cycle1 = Cycle*
Cycle1_Type = 1
Cycle1_Ico = cycle.bmp
Cycle2 = Pocket*
Cycle2_Type = 1
Cycle2_Ico = cycle.bmp
...
CycleX
Definition of cycles without graphical support. Subprogram calls can also be entered here. A
language-specific text can also be specified. X stands for a cycle number, which must be the
same over three associated entries.
Syntax:
CycleX = L100(*
CycleX = L100(* "$85001"
The following is displayed, e.g.:
"L100(2,3,4)"
Language-dependent text that is stored in 85001
CycleX = L100(* "$85001/fixed
Text"
Language-dependent text that is saved in 85001 +
"/fixed text"
CycleX_Type
Definition of whether cycle is to be displayed as a sub-block or a main block
1: Sub-block
0: Main block
CycleX_Ico
Associated icon, it must be located in the directory that was specified in IconPath.
[ProgSupport_User]
Machine manufacturers can enter their expansions for their own cycles here.
Example:
;Programming Support - Siemens Standard
[ProgSupport_Siemens]
NCG_1=CYC82
NCG_2=CYC86
NCG_3=CYC83
NCG_4=CYC84
NCG_5=CYC84_1
To Next Page
Loading...
Need help?
General
