List of the INI Files
A.23 SEDITOR.INI
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
323
NCG_2_Label=NC2
NCG_2_Text=MCALL CYCLE83
NCG_2_Ico=cm_poly_dr_deepdrill.bmp
NCG_2_Level=0
Explanations:
As an example, two graphically-supported cycles are shown here.
The following lines appear in place of the cycle in the NC program:
;NCG#CYC82#\CST.DIR\bohren.com#NC1#2#*NCG;*RO*;*HD*
;#1#1#1#1#1###"M3"####1##1#*NCG;*RO*;*HD*
CYCLE82(1,2,3,4,,0)
;#END#*NCG;*RO*;*HD*
[ProgSupport_User]
No.
Here, the number of the following entries must be specified.
NCG_1
Entries of individual search texts or name of cycles.
Generally, this is the text that is located in the NC program after ";NCG#".
In the example above, this would be "CYC82".
Because there can be several versions (e.g. NC1, NC2, etc.) for such a cycle, an additional
section must be set-up in the INI file for this entry [CYC82].
Section for cycles (e.g.: [CYC82])
No.
Number of cycle versions
NCG_1_Label
"Name" of the version. Generally, this is the text that is found in the NC program after the
path of the COM file (NC1, NC2, etc.).
NCG_1_Text
Text that is displayed. A fixed text, a language-specific text ($85111), or a combination of
both ($85111/my additional text) can be specified.
NCG_1_Ico
Associated icon, it must be located in the directory that was specified in IconPath.
NCG_1_Level
Definition of whether cycle is to be displayed as a sub-block or a main block
1: Sub-block
0: Main block
Reference: Commissioning Manual "Supplement operator interface"
To Next Page
Loading...
Need help?
General
