Siemens SIPART Series - Service and maintenance

SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
9
Introduction
1
1.1
Purpose of this documentation
These instructions contain all information required to commission and use the device. It is
your responsibility to read the instructions carefully prior to installation and commissioning. In
order to use the device correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2
History
This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation of this edition is applicable for the following firmware:
Edition
Firmware identifier nameplate
10/2013
From FW 4.00.02
The most important changes in the documentation as compared to the respective previous
edition are given in the following table.
Edition
Remark
10/2013 Chapter 3 "Description" > 3.2 "Structure (Page 18)": Nameplates revised.
Chapter 8 "Functional safety"
Chapter 13 "Dimensional drawings" > 13.4 "
Positioner with flameproof enclosure
6DR5..5 (Page 258)": New graphic, new dimensions
See also
Construction (Page 237)