Siemens SIPART Series - 9.3.3 Overview parameters A to P

Parameterizing/addressing
9.3 Overview of parameters
SIPART PS2 with and without HART
154 Operating Instructions, 10/2013, A5E00074631-11
9.3.3
Overview parameters A to P
Introduction
These parameters are used to set the extended diagnostic functions of the positioner.
Note
Factory setting
Factory
-set parameter values are printed in bold in the following table.
Note
Display
Parameters A to P and their sub
-parameters are only displayed when the extended
diagnostics has been activated using parameter "XDIAG" with parameter value "On1", "On2"
or "On3".