Introduction
1.3 Purpose
SIPART PS2 with and without HART
10 Operating Instructions, 10/2013, A5E00074631-11
The electropneumatic positioner is used for the continuous control of process valves with
pneumatic drives in the following industries.
● Chemicals
● Oil and gas
● Energy production
● Food and beverages
● Pulp and paper
● Water/waste water
● Pharmaceutical industry
● Offshore plants
Operate the device according to the specifications in Chapter "Technical data (Page 235)".
For additional information, refer to the operating instructions for the device.
1. Check the packaging and the device for visible damage caused by inappropriate handling
during shipping.
2. Report any claims for damages immediately to the shipping company.
3. Retain damaged parts for clarification.
4. Check the scope of delivery by comparing your order to the shipping documents for
correctness and completeness.
Using a damaged or incomplete device
Danger of explosion in hazardous areas.
• Do not use damaged or incomplete devices.
To Next Page
Loading...
