Installing/mounting
4.2 Mounting the linear actuator
SIPART PS2 with and without HART
34 Operating Instructions, 10/2013, A5E00074631-11
The device can be damaged, destroyed, or its functionality impaired through improper
mounting.
• Before installing ensure there is no visible damage to the device.
• Make sure that process connectors are clean, and suitable gaskets and glands are
used.
• Mount the device using suitable tools. Refer to the information in Chapter "Technical
data (Page 235)", for example installation torques requirements.
Loss of degree of protection
Damage to device if the enclosure is open or not properly closed. The degree of protection
specified on the nameplate or in Chapter "Technical data (Page 235)" is no longer
guaranteed.
• Make sure that the device is securely closed.
Mounting the linear actuator
Requirements
There are linear actuators for standard mounting and for integrated pneumatic mounting.
Use the reduced mounting kit 6DR4004-8VK for actuators with integrated mounting.
This chapter describes how to connect the positioner to the actuator using the mounting kit
6DR4004-8V. You require different installation parts of this mounting kit depending on the
selected actuator type. All installation parts listed in the following table are included in the
product package of the mounting kit 6DR4004-8V. The mounting kit is suitable for a stroke of
3 to 35 mm. For a larger stroke range, you require a lever 6DR4004-8L which is to be
ordered separately. Keep the suitable installation parts ready:
To Next Page
Loading...
