Commissioning
7.5 Commissioning part-turn actuators
SIPART PS2 with and without HART
134 Operating Instructions, 10/2013, A5E00074631-11
3. Call the "2.YAGL" parameter. To do this, briefly press the button. This parameter has
already been set to 90° automatically. The display shows the following:
4. Call the "4.INITA" parameter. To do this, briefly press the
button. The display shows
the following:
5. Start the initialization process. To do this, press the
button for at least 5 seconds until
the display shows the following:
The positioner runs through five initialization steps during the automatic initialization
process. Displays for the initialization steps from "RUN1" to "RUN5" are shown in the
lower line on the display. The initialization process depends on the actuator used, and
takes up to 15 minutes.
6. The following display indicates that the automatic initialization is complete. The total angle
of rotation of the actuator is shown on the upper line on the display:
Aborting the automatic initialization process
1. Press the button. The display shows the following:
The positioner is in the "Configuration" mode.
2. Exit the "Configuration" mode. To do this, press the
button for at least 5 seconds.
The software status is displayed.
After releasing the
button, the positioner is in "P manual mode". The part-turn actuator
is not initialized.
To Next Page
Loading...
