Siemens SIPART Series - Page 162

Parameterizing/addressing
9.4 Description of parameters
SIPART PS2 with and without HART
160 Operating Instructions, 10/2013, A5E00074631-11
4.INITA - automatic initialization
Use this parameter to start the automatic initialization process. Select the "Strt" parameter
value. Then press the
button for at least 5 seconds. The sequence of the initialization
process from "RUN1" to "RUN5" is output in the bottom line of the display.
The factory setting is "NOINI".
5.INITM - manual initialization
Use this parameter to start the manual initialization process. Select the "Strt" parameter
value. Then press the
button for at least 5 seconds.
Note
If the positioner has already been initialized and if the "INITA" and "INITM" values are set, it
is possible to reset the positioner to the non
-initialized status. To do this, press the button
for at least 5 second
s.
The factory setting is "NOINI".
See also
Commissioning (Page 113)
Sequence of automatic initialization (Page 117)
Manual initialization of linear actuators (Page 128)
Manual initialization of part-turn actuators (Page 135)