Siemens SIPART Series User Manual

Parameterizing/addressing
9.4 Description of parameters
SIPART PS2 with and without HART
182 Operating Instructions, 10/2013, A5E00074631-11
C2.FACT1 - factor 1
Use this sub-parameter to set the factor for the formation of limit threshold 1. Set the factor in
a range from "0.1" to "100.0". The limit threshold is the product of "C1.LIMIT" and
"C2.FACT1".
The threshold 1 error message is displayed when the limit threshold 1 is exceeded. The
procedure to activate and display this fault message is described in the "XDIAG" parameter.
The factory setting is "1.0".
C3.FACT2 - factor 2
Use this sub-parameter to set the factor for the formation of limit threshold 2. Set the factor in
a range from "0.1" to "100.0". The limit threshold is the product of "C1.LIMIT" and
"C3.FACT2".
The threshold 2 error message is displayed when the limit threshold 2 is exceeded. The
procedure to activate and display this fault message is described in the "XDIAG" parameter.
The factory setting is "1.5".
C4.FACT3 - factor 3
Use this sub-parameter to set the factor for the formation of limit threshold 3. Set the factor in
a range from "0.1" to "100.0". The limit threshold is the product of "C1.LIMIT" and
"C4.FACT3".
The threshold 3 error message is displayed when the limit threshold 3 is exceeded. The
procedure to activate and display this fault message is described in the "XDIAG" parameter.
The factory setting is "2.0".

Siemens SIPART Series Specifications

General

Brand	Siemens
Model	SIPART Series
Category	Accessories
Language	English