Siemens SIPART Series User Manual

Alarm, error, and system messages
10.3 Online diagnostics
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
221
Error
code
Three-
stage
Event
Parameter setting
Error message disappears
when
Possible causes
12 Yes Static friction/
Slipstick effect
occurs
d. STIC≠OFF ... Slipjumps can no longer be
detected, or the function is
deactivated.
Increased static friction, valve
no longer moves smoothly,
but with jerks
13 Yes Temperature
undershot
H. TMIN≠OFF ... the lower temperature
thresholds are no longer
undershot.
Ambient temperature too low
14 Yes Temperature
overshot
J. TMAX≠OFF ... the upper thresholds are
no longer overshot.
Ambient temperature too high
15 Yes Position average
deviates from the
reference value
P. PAVG≠OFF ... the position average
calculated after a comparison
interval is again within the
thresholds for the reference
value, or the function is
deactivated.
In the last comparison
interval, the valve trajectory
was changed so severely that
a deviating position average
was calculated.
1)
Refer to the corresponding parameter descriptions for additional information about parameters
See also
Overview of parameters 1 to 5 (Page 149)
Overview of parameters 6 to 51 (Page 150)

Siemens SIPART Series Specifications

General

Brand	Siemens
Model	SIPART Series
Category	Accessories
Language	English