Siemens SIPART Series - Commissioning

Table of contents
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
5
6.2.1 Overview of operating modes .................................................................................................... 104
6.2.2 Changing the operating mode .................................................................................................... 105
6.2.3 Overview of configuration .......................................................................................................... 106
6.2.4 Description of operating modes ................................................................................................. 107
6.3 Optimizing the controller data .................................................................................................... 110
7 Commissioning ................................................................................................................................... 113
7.1 Basic safety instructions ............................................................................................................ 113
7.2 Sequence of automatic initialization .......................................................................................... 117
7.3 Purge air switching ..................................................................................................................... 122
7.4 Commissioning linear actuators ................................................................................................. 123
7.4.1 Preparing linear actuators for commissioning ............................................................................ 123
7.4.2 Automatic initialization of linear actuators .................................................................................. 124
7.4.3 Manual initialization of linear actuators ...................................................................................... 128
7.5 Commissioning part-turn actuators ............................................................................................ 132
7.5.1 Preparing part-turn actuators for commissioning ....................................................................... 132
7.5.2 Automatic initialization of part-turn actuators ............................................................................. 133
7.5.3 Manual initialization of part-turn actuators ................................................................................. 135
7.6 Device replacement ................................................................................................................... 138
8 Functional safety ................................................................................................................................. 141
8.1 Range of applications for functional safety ................................................................................ 141
8.2 Safety function ........................................................................................................................... 141
8.3 Safety Integrity Level (SIL) ......................................................................................................... 143
8.4 Settings ...................................................................................................................................... 144
8.5 Safety characteristics ................................................................................................................. 144
8.6 Maintenance/check .................................................................................................................... 145
9 Parameterizing/addressing .................................................................................................................. 147
9.1 Parameter chapter ..................................................................................................................... 147
9.2 Configuration schematic for parameter operating principle ....................................................... 148
9.3 Overview of parameters ............................................................................................................. 149
9.3.1 Overview of parameters 1 to 5 ................................................................................................... 149
9.3.2 Overview of parameters 6 to 51 ................................................................................................. 150
9.3.3 Overview parameters A to P ...................................................................................................... 154
9.4 Description of parameters .......................................................................................................... 158
9.4.1 Description of parameters 1 through 5 ...................................................................................... 158
9.4.2 Description of parameters 6 through 51 .................................................................................... 161
9.4.2.1 Description of parameters 6 ....................................................................................................... 161
9.4.2.2 Description of parameters 7 ....................................................................................................... 161
9.4.2.3 Description of parameters 8 and 9 ............................................................................................. 162
9.4.2.4 Description of parameters 10 and 11 ......................................................................................... 163
9.4.2.5 Description of parameters 12 ..................................................................................................... 163
9.4.2.6 Description of parameters 13 through 33 .................................................................................. 164
9.4.2.7 Description of parameters 34 ..................................................................................................... 165