Simrad Maris ECDIS900 - Page 134

Selecting waypoints
Press the Delete key to delete a selection. Move a selection as described in
Modifyi ng a route
or
create a new route from the selection.
CREATE A ROUTE FROM A SELECTION OF EXISTING WAYPOINTS
• Load one or several routes.
• Make a selection of waypoints.
• Press the New Route and OK buttons in the confirmation dialogue.
• Enter a name for the new route.
• The newly created route is displayed and selected.
• To continue plotting waypoints, right click on the route and activate the menu item
Append waypoint.
EXAMPLE
Creation of a new route from three existing routes.
• The first route describes the way out of a harbour, the second one a sea passage and the
third a harbour entrance.
• Press the Crtl and Shift keys down and click on one waypoint from the first route: the first
route is added to the selection.
• Press Ctrl and click on one waypoint from the second route as shown in the picture.
• Press Ctrl and click on the next waypoint from the second route.
• Press the Crtl and Shift keys down and click on one waypoint from the last route: the last
route is added to the selection.
134