Show/hide AIS target's name
• Check box to activate alarm
• Set the value of the range
REMARK
When Alarm is active, lost targets are not remove automatically from the list after normal
timeout (1mn). Alarm acknowledgment will remove lost targets from the list.
SHOW/HIDE AIS TARGET'S NAME
To display or hide a target’s name, click right on the target icon and select Show name or Hide
name on the pop-up menu.
REMARK
The user may also select to hide or show the name from the target’s properties dialogue.
SHOW/HIDE PAST TRACK
All AIS tracks are automatically recorded in memory (Up to 3 hours).
To display or hide a track click right on the target icon and select Show past track or Hide
past track in the pop-up menu.
REMARK
The user may also select to hide or show the track from the target’s properties dialogue.
SAVE THE TRACK
To store a target’s track in the route / track database on the hard disk, click right on the target
icon and select Save track from the pop-up menu. The track is recorded for 3 hours with 30s
time stamp.
The saved AIS tracks are stored in the same database as the own ship and saved ARPA tracks.
To load/Unload a recorded target track see chapter Track.
AIS TARGET PROPERTIES
To view the properties of a target click right on the target and select Properties from the pop-
up menu.
It is also possible to view to the properties from the target list dialogue by right clicking on
the name of the target.
The General panel displays static information about the target and the Navigation panel
displays information about the voyage and the dynamic data.
189
To Next Page
Loading...
