Navigation Editor
SELECT ALL ALARM OBJECTS
Empty the selection and select all alarm objects defined by the user.
SELECT ALL NAVIGATION EDITOR
Empty the selection and select all NE loaded objects.
CONNECT POLYLINES
Select two polylines, activate the item Connect Polylines: the two lines are then connected.
ORDER
User’s data objects loaded in the ECDIS are displayed with a priority controlled in two
different and complementary ways:
Layers order: the files and the layers are displayed in an order defined by the user. See chapter
OE paragraph Layers.
Inside each OE layer the user can control the order the objects are displayed.
The item menu ‘Order’ allows changing the priority of the display of the selected object by
sending it ‘to back’, ‘to front’ or moving it one step forward or backward in the layer’s list of
objects.
IMPORTANT
The function Order is applicable only on the active layer. To change the display priority of
objects belonging to other layer the user must first activate the layer. See Chapter OE,
paragraph Layer.
SWITCHING TO THE RHUMBLINE MODE OR SWITCHING TO THE GREAT CIRCLE MODE
Display all lines either in Rhumline mode either in Great Circle.
NAVIGATION EDITOR
N
AVIGATION EDITOR
The Navigation Editor gives the user the possibility of working with the electronic chart in the
same way as with the paper chart:
• Preparation of a harbour arrival or a passage through a dangerous area by adding
temporary information on the chart.
• Planning the route more safely by drawing restricted or dangerous zones.
• Manually plotting the position of the ship.
Information and objects plotted with the NE (Navigation Editor) are stored and presented in a
special layer called NE layer that is displayed on the top of the electronic chart.
220
To Next Page
Loading...
