Simrad Maris ECDIS900 - Set a New Waypoint Latitude; Et a New Waypoint Latitude Longitude

Set a new waypoint latitude/longitude
Double clicking on a waypoint name
centres the chart
on that waypoint. Right clicking on the
waypoint name allows the user to
Move that waypoint in the list
or to set the waypoint as
Waypoi nt
pil ot
.
Several values are editable (Waypoint’s position, type of leg, XTD Port, XTD Starboard, ROT
etc). Other values are calculated and therefore not modifiable (Distance to go, TTG, Range and
bearing …).
There are three ways to modify editable values:
• Press “Waypoint properties” button to access editing dialogue
• Click on a value in the list and edit that value in the pop-up box.
• Click the column title of an editable value to change all values in the column at the same
time (SOG, Turning radius, XTD).
IMPORTANT
When the route is locked the buttons are disabled and fields cannot be edited. Unlock the
route to make the components editable.
NOTE
Modifications carried out in the route plan dialogue box are immediately
displayed on the chart and the changes can be graphically checked
List of available functions:
•
Change the Route name
•
Set a new waypoint latitude/longitude
•
Change waypoint's name
•
Rename the waypoint
•
Change the type of leg
•
Delete a waypoint
•
Centre the chart on a waypoint's location
•
Print the Route Plan
•
Set a waypoint as Pi l ot waypoi nt
•
Set a new turning radius
•
Set a new XTD
•
Set a new SOG
•
Set a new ETA
•
Add a new waypoi nt by coordinates
•
Add a new waypoint by range and bearing
•
Modify the waypoi nt t i me zone
•
Add an existi ng route to the current route
•
Move a waypoint in the list
SET A NEW WAYPOINT LATITUDE/LONGITUDE
Click on the latitude and modify the value.
145