Simrad Maris ECDIS900 - Page 138

Modifying a route
MOVE A WAYPOINT
• To move a waypoint on the chart, locate the cursor over the waypoint, click and hold and
then drag the waypoint to the new position.
• To move a waypoint via the keyboard, see
Waypoi nt properties
or
Route Pl an
.
IMPORTANT
In case of a mistake it is possible to go back a step. Right click on the route and select
the menu item “Undo”. The waypoint is put back at the original position.
MOVE A SELECTION
• To move a selection of waypoints, locate the cursor on one of the selected waypoints,
click and hold and then drag the selection to the new position.
INSERT A WAYPOINT
• Locate the cursor on a segment where a new waypoint is desired and click right.
• Select Insert new mark on the pop-up menu.
To insert a waypoint via the keyboard, see
Rout e Plan
.
APPEND A WAYPOINT
• Locate the cursor on the last leg. Right click and select Append new waypoint from the
drop down menu. A new waypoint will be appended to the end of the route. Move the
cursor to the desired position. The new segment will display the appropriate length and
heading
• To stop adding new waypoints double click on the last waypoint entered.
DELETE A WAYPOINT
• Locate the cursor on a waypoint that is to be deleted, right click and select the menu item
Delete.
• Alternatively select the waypoint by clicking once on it and press the Delete key.
• To delete a waypoint via the keyboard, see
Rout e Plan
.
IMPORTANT “Undo” can be used to recover a route.
SPLIT A ROUTE
• Locate the cursor on a leg, right click and select Split on the pop-up menu. The leg
disappears and two independent routes are created. Note that the two new routes are
given different names.
REVERSE A ROUTE
• Locate the cursor on any route leg, right click and select Reverse in the pop-up menu.
138