SLE 5000 - Ventilation Mode Panel Functions

Page 42
The panel also displays software version numbers
and the controller checksum for the controller
subsystem. The Elapsed time counter shows the
accumulated days and hours the ventilator has
been turned on.
10.7 Mode Panel Functions in a
Ventilation Mode
For each ventilation mode, extra mode specific
functions are displayed in the panel (except HFO
Only).
SLE4000 & SLE5000
For CPAP (with flow sensor)
Apnoea Setup, Set Trigger (Flow) and
TTV
plus
buttons.
For CPAP (without flow sensor)
Apnoea Setup, Set Trigger (Pressure)
buttons.
For CPAP (without flow sensor and Apnoea alarm
delay set to OFF)
Set Trigger (Pressure) for monitoring
only.
For CMV (with flow sensor)
TTV
plus
button.
For CMV (without flow sensor)
No extra functions.
For PTV (with flow sensor)
Apnoea Setup, Set Trigger (Flow) and
TTV
plus
buttons.
For PTV (without flow sensor)
Apnoea Setup, Set Trigger (Pressure)
For PSV (with flow sensor)
PSV setup, Apnoea Setup, Set Trigger
(Flow) and TTV
plus
buttons.
For PSV (without flow sensor)
Apnoea Setup and Set Trigger
(Pressure).
PSV button available but termination
sensitivity disabled.
For SIMV (with flow sensor)
PSV setup, Apnoea Setup, Set Trigger
and TTV
plus
buttons.
For SIMV (without flow sensor)
PSV setup, Apnoea Setup, Set Trigger
SLE5000 Only
For HFO+CMV HFO Activity
The Mode Select button, Standby button and
Service Data button are common to all mode
panels.