SLE 5000 - Page 8

Page 8
29.4 Cleaning Method................................... 151
29.4.1 Ventilator ............................................... 151
29.4.2 Flow Sensor .......................................... 151
29.4.3 Exhalation block .................................... 151
29.5 Disinfection Method .............................. 151
29.5.1 Ventilator. .............................................. 151
29.5.2 Flow Sensor .......................................... 151
29.5.3 Exhalation block .................................... 151
29.6 Sterilization Method .............................. 151
30. Technical Specification ............................ 152
30.1 Operating Modes Conventional
Ventilation ............................................. 152
30.1.1 CPAP .................................................... 152
30.1.2 CMV ...................................................... 152
30.1.3 PTV ....................................................... 152
30.1.4 PSV....................................................... 152
30.1.5 SIMV ..................................................... 153
30.1.6 HFO Ventilation..................................... 153
30.1.7 HFO+CMV ............................................ 153
30.1.8 Controls (Via touchscreen display) ....... 154
30.1.9 Controls................................................. 155
30.2 Measurement ........................................ 155
30.2.1 Flow and Volume .................................. 155
30.2.2 Oxygen Concentration .......................... 155
30.2.3 Pressure................................................ 156
30.3 Exhalation Block Port Jet Sizes ............ 156
30.4 Alarms................................................... 156
30.4.1 User settable Alarms............................. 156
30.4.2 Obligatory Alarms (non adjustable by
user)...................................................... 156
30.5 Patient circuits....................................... 157
30.6 Outputs ................................................. 157
30.7 Gas supplies ......................................... 158
30.7.1 Oxygen supply ...................................... 158
30.7.2 Air supply .............................................. 158
30.7.3 Input pressures and ventilator
performance.......................................... 158
30.8 Power, Dimensions, Classification etc. . 158
30.8.1 Operating Environment: ........................ 158
30.8.2 Connectors............................................ 158
30.9 Classification ......................................... 158
30.10 Environmental Storage Conditions ....... 158
31. Functional Testing ................................... 160
31.1 Functional testing .................................. 160
31.1.1 Complete Power Fail Alarm Test. ......... 160
31.1.2 Back-up alarm speaker test .................. 161
31.1.3 Setting O
2
% .......................................... 161
31.1.4 Functional Testing without a Flow
Sensor................................................... 161
31.1.5 Calibration of the Flow sensor .............. 161
31.1.6 Oxygen Alarm Test ............................... 162
31.1.7 Function and Alarm Testing .................. 163
31.1.8 High Pressure Alarm ............................. 165
31.1.9 Low Pressure Alarm.............................. 165
31.1.10 Breath Not Detected Alarm ................... 166
31.1.11 Leak / Block Alarm ................................ 166
31.1.12 Mains Failure Alarm .............................. 167
31.1.13 Gas Supply Alarms ............................... 167
31.1.14 Flow Sensor Disconnect Alarm ............. 168
31.1.15 Cycle Fail Alarm .................................... 168
31.1.16 Functional Test of HFO Mode ............... 173
31.1.17 Functional Test of HFO+CMV Mode..... 175
31.1.18 Pressure Change Alarm ........................ 176
32. EMC compliance ........................................178
32.1 Electromagnetic immunity ..................... 179
32.2 Recommended separation distances
between portable and mobile RF
communications equipment and the
SLE4000 & SLE5000181
33. Pneumatic Unit Schematic SLE4000 Model
H, K & N .......................................................182
34. Pneumatic Unit Schematic SLE5000 Model
G, G-R, J, L & M ..........................................183
35. Ventilator Labelling ...................................184
35.1 SLE4000 model N ................................. 184
35.2 SLE5000 Model M-1 ............................. 185
36. Consumables and Accessories ...............188
37. Glossary of Abbreviations Used in this
Manual .........................................................194
38. Index ...........................................................195