C
ONFIGURING
SNMP
2-109
Specifying Trap Managers
You can specify up to five management stations that will receive
authentication failure messages and other trap messages from the
switch.
Command Usage
• If you do not enter a trap manager host IP address, no
notifications are sent. In order to configure the switch to send
SNMP notifications, you must enter at least one host IP address.
• The switch can send SNMP version 1 or version 2c traps to a
host IP address, depending on the SNMP version that the
management station supports. The default is to send SNMP
version 1 traps.
• You can enable or disable authentication messages and
link-up-down messages via the Web interface.
• You can enable or disable authentication messages,
link-up-down messages, or all notification types via the CLI.
b_mgmt.book Page 109 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
