C
OMMAND
L
INE
I
NTERFACE
3-12
Command Groups
The system commands can be broken down into the functional
groups shown below
.
Command
Group
Description Page
General Basic commands for entering privileged access
mode, restarting the system, or quitting the CLI
3-14
Flash/File Manages code image or switch configuration
files
3-20
System
Management
Controls system logs, system passwords, user
name, jumbo frame support, browser
management options, HTTPS, SSH, and a variety
of other system information
3-27
Authentication Configures RADIUS and TACACS+ client-server
authentication for logon access
3-55
SNMP Activates authentication failure traps; configures
community access strings, and trap managers
3-64
IP Configures the IP address and gateway for
management access, displays the default
gateway, or pings a specified device
3-73
Line Sets communication parameters for the serial
port, including baud rate and console time-out.
3-80
Interface Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
3-91
Address Table Configures the address table for filtering
specified addresses, displaying current entries,
clearing the table, or setting the aging time
3-107
Spanning Tree Configures Spanning Tree settings for the switch 3-113
VLAN Configures VLAN settings, and defines port
membership for VLAN groups
3-130
GVRP and
Bridge
Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB
3-141
b_mgmt.book Page 12 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
