IGMP S
NOOPING
C
OMMANDS
3-153
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Member types displayed include IGMP or USER, depending on
selected options.
Example
The following shows the multicast entries learned through IGMP
snooping for VLAN 1:
ip igmp snooping querier
Use this command to enable the switch as an IGMP snooping
querier. Use the no form to disable it.
Syntax
ip igmp snooping querier
no ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.1.2.3 Eth1/11 IGMP
Console#
b_mgmt.book Page 153 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
