IGMP S
NOOPING
C
OMMANDS
3-151
ip igmp snooping version
Use this command to configure the IGMP snooping version. Use
the no form to restore the default.
Syntax
ip igmp snooping version {1 | 2}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If
there are legacy devices in your network that only support
Version 1, you will also have to configure this switch to use
Version 1.
• Some commands are only enabled for IGMPv2, including ip
igmp query-max-response-time and ip igmp
router-port-expire-time.
Example
The following configures the switch to use IGMP Version 1:
Console(config)#ip igmp snooping version 1
Console(config)#
b_mgmt.book Page 151 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
