C
ONFIGURING
THE
S
WITCH
2-14
If you lose your management connection, use a console
connection and enter show ip interface to determine the new
switch address.
CLI – Specify the management interface, and set the IP Address
Mode to DHCP or BOOTP.
Renewing DCHP – DHCP may lease addresses to clients
indefinitely or for a specific period of time. If the address expires
or the switch is moved to another network segment, you will lose
management access to the switch. In this case, you can reboot the
switch or submit a client request to restart DHCP service.
Web – If the address assigned by DHCP is no longer functioning,
you will not be able to renew the IP settings via the Web interface.
You can only restart DHCP service via the Web interface if the
current address is still available.
CLI – Enter the following command to restart DHCP service.
Security
Configuring the Logon Password
The guest only has read access for most configuration parameters.
However, the administrator has write access for parameters
governing the onboard agent. You should therefore assign a new
Console(config)#interface vlan 1 3-92
Console(config-if)#ip address dhcp 3-74
Console(config-if)#end
Console#ip dhcp restart 3-75
Console#show ip interface 3-77
IP address and netmask: 10.1.0.54 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#
Console#ip dhcp restart 3-75
b_mgmt.book Page 14 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
