IP C
OMMANDS
3-73
IP Commands
An IP address may be used for management access to the switch
over your network. By default, the switch uses DHCP to assign IP
settings to VLAN 1 on the switch. If you wish to manually
configure IP settings, you need to change the switch’s
user-specified defaults (IP address 0.0.0.0 and netmask 255.0.0.0)
to values that are compatible with your network. You may also
need to a establish a default gateway between the switch and
management stations that exist on another network segment.
Command Function Mode Page
ip address Sets the IP address for this device IC 3-74
ip dhcp restart Submits a BOOTP or DCHP client
request
PE 3-75
ip
default-gateway
Defines the default gateway through
which an in-band management station
can reach this device
GC 3-76
show ip interface Displays the IP settings for this device PE 3-77
show ip redirects Displays the default gateway configured
for this device
PE 3-78
ping Sends ICMP echo request packets to
another node on the network
NE,
PE
3-78
b_mgmt.book Page 73 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
