SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart - Configure

C OMMAND L INE I NTERFACE
3-16
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to
indicate that the system is in normal access mode.
Example
Related Commands
enable (3-14)
configure
Use this command to activate Global Configuration mode. You
must enter this mode to modify any settings on the switch. You
must also enter Global Configuration mode prior to enabling some
of the other configuration modes, including Interface
Configuration, Line Configuration, and VLAN Database
Configuration. See “Understanding Command Modes” on page 3-7.
Default Setting
None
Command Mode
Privileged Exec
Example
Related Commands
end (3-18)
Console#disable
Console>
Console#configure
Console(config)#
b_mgmt.book Page 16 Tuesday, July 8, 2003 5:24 PM