SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart User Manual

IGMP S NOOPING C OMMANDS
3-157
Related Commands
ip igmp snooping version (3-151)
ip igmp snooping router-port-expire-time
Use this command to configure the snooping query timeout. Use
the no form of this command to restore the default.
Syntax
ip igmp snooping router-port-expire-time seconds
no ip igmp snooping router-port-expire-time
seconds - The time the switch waits after the previous
querier stops before it considers the router port (i.e., the
interface which had been receiving query packets) to have
expired. (Range: 300-500)
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The switch must be using IGMPv2 for this command to take
effect.
Example
The following shows how to configure the default timeout to 300
seconds:
Related Commands
ip igmp snooping version (3-151)
Console(config)#ip igmp snooping query-time-out 300
Console(config)#
b_mgmt.book Page 157 Tuesday, July 8, 2003 5:24 PM

SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart Specifications

General

Brand	SMC Networks
Model	SMC EZ Switch 10/100/1000 SMCGS8P-Smart
Category	Switch
Language	English