A
DDRESS
T
ABLE
C
OMMANDS
3-111
Example
clear mac-address-table dynamic
Use this command to remove any learned entries from the
forwarding database and to clear the transmit and receive counts
for any static or system configured entries.
Default Setting
None
Command Mode
Privileged Exec
Example
mac-address-table aging-time
Use this command to set the aging time for entries in the address
table. Use the no form to restore the default aging time.
Syntax
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Time is number of seconds (17-2184).
Default Setting
300 seconds
Console#show mac-address-table
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/ 1 00-e0-29-94-34-de 1 Delete-on-reset
Console#
Console#clear mac-address-table dynamic
Console#
b_mgmt.book Page 111 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
