SNMP C
OMMANDS
3-67
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (3-66)
snmp-server host
Use this command to specify the recipient of a Simple Network
Management Protocol notification operation. Use the no form to
remove the specified host.
Syntax
snmp-server host {host-addr community-string} [version 1 |
2c]
no snmp-server host host-addr
• host-addr - Name or Internet address of the host (the targeted
recipient). (Maximum host addresses: 5 trap destination IP
address entries)
• community-string - Password-like community string sent
with the notification operation. Though you can set this string
using the snmp-server host command by itself, we
recommend you define this string using the snmp-server
community command prior to using the snmp-server host
command. (Maximum length: 32 characters)
• version - Specifies whether to send notifications as SNMP v1
or SNMP v2c traps.
Console(config)#snmp-server location WC-19
Console(config)#
b_mgmt.book Page 67 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
