C
OMMAND
L
INE
I
NTERFACE
3-2
3. When finished, exit the session with the “quit” or “exit”
command.
After connecting to the system through the console port, the login
screen displays:
Telnet Connection
Telnet operates over the IP transport protocol. In this environment,
your management station and any network device you want to
manage over the network must have a valid IP address. Valid IP
addresses consist of four numbers, 0 to 255, separated by periods.
Each address consists of a network portion and host portion. For
example, the IP address assigned to this switch, 10.1.0.1, consists
of a network portion (10.1.0) and a host portion (1).
To access the switch through a Telnet session, you must first set
the IP address for the switch, and set the default gateway if you
are managing the switch from a different IP subnet. For example:
If your corporate network is connected to another network outside
your office or to the Internet, you need to apply for a registered IP
address. However, if you are attached to an isolated network, then
you can use any IP address that matches the network segment to
which you are attached.
User Access Verification
Username: admin
Password:
CLI session with the SMC8612T is opened.
To end the CLI session, enter [Exit].
Console#
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.1 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254
b_mgmt.book Page 2 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
