SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart - Show Garp Timer

GVRP AND B RIDGE E XTENSION C OMMANDS
3-145
Note: Set GVRP timers on all Layer 2 devices connected in the
same network to the same values. Otherwise, GVRP will
not operate successfully.
Example
Related Commands
show garp timer (3-145)
show garp timer
Use this command to show the GARP timers for the selected
interface.
Syntax
show garp timer [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
Default Setting
Shows all GARP timers.
Command Mode
Normal Exec, Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#
b_mgmt.book Page 145 Tuesday, July 8, 2003 5:24 PM