A
DDRESS
T
ABLE
C
OMMANDS
3-107
• Priority for untagged traffic – Indicates the default priority
for untagged frames (page 3-160).
• Gvrp status – Shows if GARP VLAN Registration Protocol is
enabled or disabled (page 3-142).
• Allowed Vlan – Shows the VLANs this interface has joined,
where “(u)” indicates untagged and “(t)” indicates tagged
(page 3-138).
• Forbidden Vlan – Shows the VLANs this interface can not
dynamically join via GVRP (page 3-139).
Example
This example shows the configuration setting for Ethernet port 15.
Address Table Commands
These commands are used to configure the address table for
filtering specified addresses, displaying current entries, clearing the
table, or setting the aging time.
Console#show interfaces switchport ethernet 1/15
Information of Eth 1/15
broadcast threshold: Enabled, 256 packets/second
Lacp status: Disabled
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Enabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Console#
Command Function Mode Page
mac-address-table
static
Maps a static address to a port in a
VLAN
GC 3-108
show
mac-address-table
Displays entries in the forwarding
database
PE 3-109
b_mgmt.book Page 107 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
