C
ONFIGURING
THE
S
WITCH
2-30
CLI – Enter the IP address of the TFTP server, specify the source
file on the server, and set the startup file name on the switch. If
you download the startup configuration file under a new file
name, you can set this file as the startup file at a later time, and
then restart the switch.
Copying the Running Configuration to a File
You can save the current running configuration to a new file name
and then set it as the startup file. Enter a name for the new
configuration file, and then click Copy to File.
Console#copy tftp startup-config 3-21
TFTP server ip address: 192.168.1.19
Source configuration file name: startup2.0
Startup configuration file name [startup] : startup2.0
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system config: startup2.0 3-26
Console(config)#exit
Console#reload
b_mgmt.book Page 30 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
