S
PANNING
T
REE
P
ROTOCOL
C
ONFIGURATION
2-51
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Usage
The range for the aging time is 17 - 2184 seconds. (The default is
300 seconds.)
Web – Click Address Table, Address Aging. Specify the new aging
time, then click Apply.
CLI – This example sets the aging time to 400 seconds.
Spanning Tree Protocol Configuration
The Spanning Tree Protocol (STP) can be used to detect and
disable network loops, and to provide backup links between
switches, bridges or routers. This allows the switch to interact with
other bridging devices (i.e., an STP-compliant switch, bridge or
router) in your network to ensure that only one route exists
between any two stations on the network, and provide backup
links that automatically take over when a primary link goes down.
Console(config)#mac-address-table aging-time 400 3-111
Console(config)#
b_mgmt.book Page 51 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
