SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart - Port Security Configuration

C ONFIGURING THE S WITCH
2-46
Port Security Configuration
On the Port/Port Security Status page, you can enable/disable
security for any switch port. For each port number listed in the
“Port” column, you can configure the following parameter:
• Security Status — Enables or disables port security on the
port. (Default: disabled)
Note: If a port is disabled due to a security violation, it must be
manually re-enabled from the Port/Port Configuration page.
Web – Click Port, Port Security Status. Check the checkbox in the
Security Status column to enable security for a port, then click
Apply.
CLI – Use the interface command to select the target port, then use
the port security action command to configure the port intrusion
action (applies to all ports). Use the port security command to
enable security for the port.
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap-and-shutdown 3-101
Console(config-if)#port security
Console(config-if)#
b_mgmt.book Page 46 Tuesday, July 8, 2003 5:24 PM