P
ORT
C
ONFIGURATION
2-45
• It can be configured as an LACP trunk port, but the switch does
not allow the LACP trunk to be enabled.
Note: A port that is already configured as an LACP or static trunk
port cannot be enabled as a secure port.
Port Security Action
The switch allows you to set the security action to be taken when
a port intrusion is detected. This setting applies to all ports on the
switch.
• Shutdown and Trap — Indicates the action to be taken when
a port security violation is detected:
- None: Indicates that no action should be taken. (This is the
default.)
- Trap and Shutdown: Indicates that the port is to be disabled
and an SNMP trap message sent.
Web – Click Port, Port Security Action. Specify the security action
for a port intrusion, then click Apply.
b_mgmt.book Page 45 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
