C
ONFIGURING
THE
S
WITCH
2-122
Web – Click IGMP, IGMP Member Port Table. Specify the interface
attached to a multicast service (via an IGMP-enabled switch or
multicast router), indicate the VLAN that will propagate the
multicast service, specify the multicast IP address, and then click
Add. After you have completed adding ports to the member list,
click Apply.
CLI – This example assigns a multicast address to VLAN 1, and
then displays all the known multicast services supported on
VLAN 1.
Showing Device Statistics
You can display standard statistics on network traffic from the
Interfaces Group and Ethernet-like MIBs, as well as a detailed
breakdown of traffic based on the RMOM MIB. Interfaces and
Ethernet-like statistics display errors on the traffic passing through
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12
ethernet 1/12
3-150
Console(config)#exit
Console#show mac-address-table multicast vlan 1
3-152
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.0.0.12 Eth1/12 USER
1 224.1.2.3 Eth1/12 IGMP
Console#
b_mgmt.book Page 122 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
