L
INE
C
OMMANDS
3-87
Default Setting
The default value is no silent-time.
Command Mode
Line Configuration
Command Usage
If the password threshold was not set with the
password-thresh command, silent-time begins after the
default value of three failed logon attempts.
Example
To set the silent time to 60 seconds, enter this command:
Related Commands
password-thresh (3-85)
databits
Use this command to set the number of data bits per character that
are interpreted and generated by the console port. Use the no
form to restore the default value.
Syntax
databits {7 | 8}
no databits
• 7 - Seven data bits per character.
• 8 - Eight data bits per character.
Default Setting
8 data bits per character
Console(config-line)#silent-time 60
Console(config-line)#
b_mgmt.book Page 87 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
