P
RIORITY
C
OMMANDS
3-161
switchport priority default
Use this command to set a priority for incoming untagged frames,
or the priority of frames received by the device connected to the
specified interface. Use the no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged
ingress traffic. The priority is a number from 0 to 7. Seven is
the highest priority.
Default Setting
The priority is not set, and the default value for untagged
frames received on the interface is zero.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Precedence or IP
DSCP, and default switchport priority.
• The default priority applies for an untagged frame received on
a port set to accept all frame types (i.e, receives both untagged
and tagged frames). This priority does not apply to IEEE 802.1Q
VLAN tagged frames. If the incoming frame is an IEEE 802.1Q
VLAN tagged frame, the IEEE 802.1p User Priority bits will be
used.
show map ip
precedence
Shows the IP precedence map PE 3-171
show map ip dscp Shows the IP DSCP map PE 3-172
Command Function Mode Page
b_mgmt.book Page 161 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
