C
OMMAND
L
INE
I
NTERFACE
3-170
map ip dscp (Interface Configuration)
Use this command to set IP DSCP priority (i.e., Differentiated
Services Code Point priority). Use the no form to restore the
default table.
Syntax
map ip dscp dscp-value cos cos-value
no map ip dscp
• dscp-value - 8-bit DSCP value. (Range: 0-255)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
The list below shows the default priority mapping. Note that all
the DSCP values that are not specified are mapped to CoS
value 0.
Command Mode
Interface Configuration (Ethernet, Port Channel)
IP DSCP Value CoS Value
00
81
10, 12, 14, 16 2
18, 20, 22, 24 3
26, 28, 30, 32, 34, 36 4
38, 40, 42 5
48 6
46, 56 7
b_mgmt.book Page 170 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
