S
YSTEM
M
ANAGEMENT
C
OMMANDS
3-51
show running-config
Use this command to display the configuration information
currently in use.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show
startup-config command to compare the information in
running memory to the information stored in non-volatile
memory.
• This command displays settings for key command modes. Each
mode group is separated by “!” symbols, and includes the
configuration mode command, and corresponding commands.
This command displays the following information:
- SNMP community strings
- Users (names, access levels, and encrypted passwords)
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- IP address configured for VLANs
- Routing protocol configuration settings
- Spanning tree settings
- Any configured settings for the console port and Telnet
b_mgmt.book Page 51 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
