C
OMMAND
L
INE
I
NTERFACE
3-128
• RSTP only works on point-to-point links between two bridges.
If you designate a port as a shared link, RSTP is forbidden.
Example
show spanning-tree
Use this command to show the configuration for the Spanning
Tree.
Syntax
show spanning-tree [interface]
• interface
• ethernet unit/port-number
- unit - This is device 1.
- port-number
• port-channel channel-id (Range: 1-6)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
•Use the show spanning-tree command with no parameters to
display the Spanning Tree configuration for the Spanning Tree
and for every interface in the tree.
•Use the show spanning-tree interface command to display
the Spanning Tree configuration for an interface within the
Spanning Tree
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree link-type point-to-point
Console(config-if)#
b_mgmt.book Page 128 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
