SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart - Ip Igmp Snooping Query-Interval

IGMP S NOOPING C OMMANDS
3-155
Example
The following shows how to configure the query count to 10:
ip igmp snooping query-interval
Use this command to configure the snooping query interval. Use
the no form to restore the default.
Syntax
ip igmp snooping query-interval seconds
no ip igmp snooping query-interval
seconds - The frequency at which the switch sends IGMP
host-query messages. (Range: 60-125)
Default Setting
125 seconds
Command Mode
Global Configuration
Example
The following shows how to configure the query interval to 100
seconds:
Console(config)#ip igmp snooping query-count 10
Console(config)#
Console(config)#ip igmp snooping query-interval 100
Console(config)#
b_mgmt.book Page 155 Tuesday, July 8, 2003 5:24 PM