C
ONFIGURING
THE
S
WITCH
2-24
Note: The switch must be reset for the new certificate to be
activated. To reset the switch, type:
Console#reload
Configuring SSH
The Secure Shell (SSH) server feature provides remote
management access via encrypted paths between the switch and
SSH-enabled management station clients.
Note: There are two versions of the SSH protocol currently
available, SSH v1.x and SSH v2.x. The switch supports only
SSH v1.5.
Command Attributes
• SSH Server Status — Allows you to enable/disable the SSH
server feature on the switch.
(Default: enabled)
• SSH authentication timeout — Specifies the time interval in
seconds that the SSH server waits for a response from a client
during an authentication attempt. (Range: 1 to 120 seconds;
Default: 120 seconds)
• SSH authentication retries — Specifies the number of
authentication attempts that a client is allowed before
authentication fails and the client has to restart the
authentication process.
(Range: 1 to 5 times; Default: 3)
b_mgmt.book Page 24 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
