C
OMMAND
L
INE
I
NTERFACE
3-110
• interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
• vlan-id - VLAN ID (Range: 1-4094)
• sort - Sort by address, vlan or interface.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• The MAC Address Table contains the MAC addresses associated
with each interface. Note that the Type field may include the
following types:
- Learned - dynamic address entries
- Permanent - static entry
- Delete-on-reset - static entry to be deleted when system is
reset
• The mask should be hexadecimal numbers (representing an
equivalent bit mask) in the form xx-xx-xx-xx-xx-xx that is
applied to the specified MAC address. Enter hexadecimal
numbers, where an equivalent binary bit “0” means to match a
bit and “1” means to ignore a bit. For example, a mask of
00-00-00-00-00-00 means an exact match, and a mask of
FF-FF-FF-FF-FF-FF means “any.”
• The maximum number of address entries is 8191.
b_mgmt.book Page 110 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
