C
OMMAND
L
INE
I
NTERFACE
3-28
ip http server Allows the switch to be monitored or
configured from a browser
GC 3-34
ip http
secure-server
Enables the HTTPS server on the switch
GC
3-35
ip http
secure-port
Specifies the UDP port number used for
HTTPS connection to the switch’s Web
interface
GC
3-36
Secure Shell Commands
ip ssh server Enables the SSH server on the switch
GC 3-38
ip ssh Specifies the authentication timeout for
the SSH server and the number of retries
allowed by a client
GC 3-37
disconnect ssh Terminates an SSH connection
PE 3-39
show ip ssh Displays the status of the SSH server and
the configured values for authentication
timeout and retries
PE
3-40
show ssh Displays the status of current SSH
sessions
PE
3-40
Event Logging Commands
logging on Controls logging of error messages GC 3-41
logging history Limits syslog messages sent to the SNMP
network management station based on
severity
GC 3-42
logging host Adds a syslog server host IP address that
will receive logging messages
GC 3-44
logging facility Sets the facility type for remote logging
of syslog messages
GC 3-45
logging trap Limits syslog messages saved to a remote
server based on severity
GC 3-45
clear logging Clears messages from the logging buffer PE 3-47
show logging Displays the state of logging PE 3-47
Command Function Mode Page
b_mgmt.book Page 28 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
Need help?
General
