SMC Networks SMC EZ Switch 10/100/1000 SMCGS8P-Smart - Page 336

C OMMAND L INE I NTERFACE
3-168
Default Setting
The list below shows the default priority mapping.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Precedence or IP
DSCP, and default switchport priority.
• IP Precedence values are mapped to default Class of Service
values on a one-to-one basis according to recommendations in
the IEEE 802.1p standard, and then mapped to the queue
defaults.
• This command sets the IP Precedence for all interfaces.
Example
The following example shows how to map IP precedence value 1
to CoS value 0:
IP Precedence Value CoS Value
00
11
22
33
44
55
66
77
Console(config)#interface ethernet 1/5
Console(config-if)#map ip precedence 1 cos 0
Console(config-if)#
b_mgmt.book Page 168 Tuesday, July 8, 2003 5:24 PM